Rm-materials-handling MANUAL CHAIN HOISTS Manuel d'utilisateur télécharger pdf (Page 13)

SERIES II I&M MANUAL/EN/

7/20

This document and the information contained herein, is the exclusive property of R&M Materials Handling, Inc., and represents a non-public, confidential and proprietary trade secret

that may not be reproduced, disclosed to third parties, altered or otherwise employed in any manner whatsoever without the express written consent of R&M Materials Handling, Inc.

1.4 Operating Practices

In addition to the Safe Operating Practices – Dos and Don’ts, it is recommended that the following operating

practices be adhered to when using a manual chain hoist.

The operator shall familiarize himself with the operation of the equipment and its proper care. If adjustments

are necessary or damage is known, the unit must be removed from service and not used until corrections are

made.

Before lifting a load, check that:

• The load chain is in good condition and properly oiled,

• The load chain is correctly fitted and not twisted or kinked,

• The load lifted is not greater than the rated capacity marked on the unit,

• Load is not caught on any obstructions,

•

Clearance is available to avoid personal injury or property damage.

During lifting a load, it’s recommended:

• To initially lift the load with caution so to check that the slings are adequate and correctly positioned,

• To stand clear while lifting or lowering the load,

• To stop lifting or lowering the load if the effort required on the hand chain is greater than normal

because the equipment may be overloaded.

• That the operator shall make sure that all people in the area are clear of the load.

• That the operator shall not engage in any activity, which will divert his attention while operating the

equipment.

• The unit shall always be operated by hand power only.

Handling the Load

• The rated load shall not be exceeded.

• The load chain shall not be wrapped around the load.

• The load shall be attached to the load hook or attached by means of slings or other approved

apparatus.

• Slings or other approved apparatus shall be seated properly in the saddle of the hook.

• Hook safety latch shall be closed before operating the unit.

• Hooks shall not be tip loaded

• The hoist shall not be operated until load-block, chain and hoist body are directly inline with the

direction of loading to avoid side pull.

• Do not leave a loaded hoist unattended at any time.

2 PACKAGING

The various models are delivered assembled and packed in cardboard boxes.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 80 81

Commentaires sur ces manuels

Pas de commentaire

Rm-materials-handling MANUAL CHAIN HOISTS Manuel d'utilisateur Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Hoist Rm-materials-handling MANUAL CHAIN HOISTS