Rm-materials-handling WIRE ROPE PACKAGES Manuel d'utilisateur télécharger pdf (Page 51)

R&M Materials Handling, Inc.

4501 Gateway Boulevard

Springfield, Ohio 45502

P.: (937) 328-5100

FAX: (937) 325-5319

51/76

R&M Materials Handling, Inc. reserves the right to alter or amend the above information without notice.

10.2 Joint plate assembly, underrunning end carriages

Pos. Connection Friction rings

BA, BB, SA, SB Bottom connection Yes

Tightening torque

Screw size Tightening torque

M16-10.9 280 Nm

M20-10.9 550 Nm

• Check that joint surfaces are free from dirt, dust and loose particles.

• Place friction rings around screw holes at bottom of end carriage.

• Place joint plate bottom of the end carriage. Make sure, that friction rings are kept in position

during assembly.

• Assemble screws and nuts.

• Assemble joint plate into final position and tighten screws with correct torque.

• Retighten screws after test runs at assembly site.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 75 76

Pas de commentaire

Rm-materials-handling WIRE ROPE PACKAGES Manuel d'utilisateur Page 51